日本語
****
Want to make PCB at home via UV method, what equipment do I need
713
1
Jan 07.2020, 17:02:41
I want to do a project at home and for that I shall need to make some PCB. I think that the UV method is best and gives most consistent results. However, I am not sure what is all the equipment I need for that and its cost. Any advice?
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP
A****min
Jan 15.2020, 10:12:45
That's great if you just want to feel the satisfaction of "having done it yourself".
You will have to place a wire (use the ends of through hole resistors so you don't burn your fingers) through every via & solder them on both sides.
If you are just looking to save money, then visit https://www.pcbgogo.com/ for a cheap quote. You will likely end up with your boards completed professionally at a much lower price than buying all the bits required to make them yourself.
