Xiuxiu Liu
Through-hole pin length and PCB thickness
2394
1
Apr 24.2019, 09:41:02
In general, how bad is it to have a through-hole component with a pin length (as measured from the PCB surface) smaller than the PCB thickness?
I would like to mount a PCB flush to a substrate, so I cannot use pins sticking out. Unfortunately the component is only available as through hole. I did a check and I am able to hand solder the component with ease. Are there long-term issues to worry about?
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP