engineer
PCB Design software
1558
1
Nov 05.2019, 18:00:09
Hi guys,
What's a good, free, design software for designing my PCB's that outputs in GERBER so I can send
to a MFG to have small batches run for me.
Need something with a low learning curve if possible.
Don't want something that links to only their mfg's.
Largest size anticipated will be about 80mm X 60mm.
If limiting factor is a little smaller, I might be able to get by with it.
Will need no more than 2 layer, most of my designs will be simple 1 layer.
Simplicity is a plus.
Never used software to do this before.Any help in this will be appreciated.
Thanks,
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP