日本語
한국어
Xiuxiu Liu
Installing labels, laminated keypads and the like.
2466
1
Dec 03.2019, 14:37:09
Are there any tricks to installing laminated polycarbonate / polyester labels and keypads?
I try to start at one edge but tend to get them askew and partly stuck down and then have to carefully peel off and start over.
For labels with a circular hole (say for a switch or similar) I've put a dowel in the hole for guidance which has helped.
Lining up keypad tails is a PITA.
Pre-clean the surface with IPA?
Just rub the label over by hand or use a firm roller?
Any tips?
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP
